EDIsecure Connect

The page outlines information on the EDIsecure connect driver

1 . Download Driver

Download EDIsecure Connect Driver v2.3.6446 from the page below.

Matica XID8300 Card Printer SupportPPC Knowledgebase

2. Unzip and Run

Unzip the file and run the file EDIsecure Connect Setup.exe

3. Connect Printer

Connect the printer via USB or Ethernet before you turn the power on.

By default the printer will boot up in Ethernet mode.

Whenever switching from USB to Ethernet or back you need to turn off the printer off.

4. Run Admin Center

Location the installation of the software, for example:

\\Program Files\DISO\EDIsecure Connect\Administration Center

Run the file AdminCenterStart.exe

5. Install a New Printer

Once running the Admin Center, you will be presented with the following screen.

Screen Image of Admin Center

• Select New Printer

• For USB installation - Select the correct USB Port (e.g.) USB Port 1

6. Configure Settings

To get the printer to print in the correct location on the cards the following settings must be set.

Printing Preference

The following settings must be set as follows:

Page Orientation - Landscape

Card Type - Smartchip Ticked (TRUE)

Layout Orientation - Set as per image

Screen Image of Printing Preference

Print Dialog

The following settings must be set as follows:

Paper Size - Card 54.0mm x 85.6mm

Margins - None

Two-sided - Print on both sides : ticked (TRUE)

Two-sided - Filp on long Edge